DV-S757
COND.
M
TV
ON
/
STANDBY
CH
+
CH
-
FUNCTION M
SEARCH
23
456
789
1
0
+
10
+
-
TV/
VCR
VOL
+
VOL
-
TV
LAST M DIMMER DISPLAY
ANGLE
STANDBY
ON
AUDIO SUBTITLE
MENU
TOP MENU
SETUPRETURN
PAUSE
DOWN UPFR FF
CLEAR
PROGRAM
DVD
RANDOM REPEAT A
-
B
STEP/
SLOW
ENTER
OPEN
/CLOSE
KEY
B
1
2
3
DVD TV
UPGRADE FIRMWARE-3
Pre programming the remote controller
Before using remote control for upgrade firmware, it is necessary to carry out the following operation.
1. Set the DVD/TV switch to TV
2. While holding down the STANDBY button
on the Remote controller that you want to
program, press the ENTER button, and
then release both button.
3. 1 key is pushed, it continues within 20 seconds,
and 0 key is pushed after that.
4. The complete of the setting of remote control.
The order of work
In the case of
upgrade firmware
In the case of
replace of the DVD main board
Check the firmware
Check the ID number
Download the firmware
Setting the regional code
Setting the ID number and data
Check the ID number
Check the firmware
Check of general operation
Replace of the DVD main board
Setting the ID number and data
Check the ID number
Check the firmware
Check of general operation
To Next Page
Loading...
