FR-N3X
1 3
42
DISASSEMBLING PROCEDURES (CD) -7
CD MECHANISM : REPLACEMENT OF DRIVE BELT
[Notes of re-assembly]
Check the lever position is at the left end.
Top side
Move to left end.
Confirm the position of marking, when attaching the
gear (Gear and Loading).
Front side
Marking
-- Top side view--
Attach the Tray
Table disk-C
-- Top side view--
[NOTES]
Even if the tray closes completely, the lever does not
move to right end.
Therefore, move the lever to right end by hand.
Check the marking on the opposite side of the gear
and the position of mark are in agreement.
Marking
--Bottom side view--
Front side
To Next Page
Loading...
