Onkyo HT-R390 User Manual

10
En
Connections
Connecting the AV Receiver
Connecting the Speaker Cables
The following illustration shows which speaker should be connected to each pair of terminals.
■ Using a Passive Subwoofer.
To find the best position for your subwoofer, while playing a
movie or some music with good bass, experiment by placing
your subwoofer at various positions within the room, and
choose the one that provides the most satisfying results
■ Push-type speaker terminals
Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the
speaker cables, and twist the bare wires tightly, as shown.
Connecting Your Speakers
Surround
right
Surround
left
Front B right Front B left Front A leftFront A right Center
Speakers ASpeakers B
Passive
Subwoofer
Corner
position
1/3 of wall
position
3/8" to 1/2" (10 to 12 mm)

Onkyo HT-R390 Specifications

General

Channels	5.1
Signal-to-Noise Ratio	100 dB (Line, IHF-A)
Speaker Impedance	6 ohms
HDMI Inputs	4
HDMI Outputs	1
Optical Inputs	2
Coaxial Inputs	1
USB Port	No
Bluetooth	No
Power Output	100 W per channel (6 ohms, 1 kHz, 1% THD)
Frequency Response	20 Hz–50 kHz
Input Sensitivity	200mV
Dolby Support	Dolby TrueHD, Dolby Digital Plus
DTS Support	DTS-HD Master Audio