Onkyo HT-R390 User Manual

17
En
Turning On & Basic Operations
Turning On/Off the AV Receiver
Tip
• See “Auto Standby” about a power management setting (➔ page 34).
Turning On
1
Press 8 ON/STANDBY on the front panel.
or
Press RECEIVER followed by 9 ON/STANDBY on the remote controller.
The AV receiver comes on, the display lights.
Turning Off
1
Press 8 ON/STANDBY on the front panel.
or
Press RECEIVER followed by 9 ON/STANDBY on the remote controller.
The AV receiver will enter standby mode. To prevent any loud surprises when you turn on the AV receiver, always
turn down the volume before you turn it off.
8ON/STANDBY
9 ON/STANDBY
RECEIVER

Onkyo HT-R390 Specifications

General

Channels	5.1
Signal-to-Noise Ratio	100 dB (Line, IHF-A)
Speaker Impedance	6 ohms
HDMI Inputs	4
HDMI Outputs	1
Optical Inputs	2
Coaxial Inputs	1
USB Port	No
Bluetooth	No
Power Output	100 W per channel (6 ohms, 1 kHz, 1% THD)
Frequency Response	20 Hz–50 kHz
Input Sensitivity	200mV
Dolby Support	Dolby TrueHD, Dolby Digital Plus
DTS Support	DTS-HD Master Audio