17
Connecting the power/Turning on the AV Receiver
Before connecting
• Make sure that all the connections from pages 10 to 16 are
complete.
• Turning on the AV Receiver may cause a momentary power
surge, which might interfere with other electrical equipment
such as computers. If this happens, use a wall outlet on a
different circuit.
1. Connect the power cord to a wall outlet.
The HT-R500 enters standby mode.
The STANDBY indicator lights up.
2. Press STANDBY/ON.
The AV Receiver turns on.
The ON indicator and display on the AV Receiver’s front panel
light. At the same time, the STANDBY indicator goes off.
Note
To turn off the AV Receiver, press STANDBY/ON. The AV
Receiver enters standby mode. Be sure to set the volume to
minimum before turning off the AV receiver.
STANDBY indicator
STANDBY/ON
STANDBY/ON
To Next Page
Loading...
