Onkyo HT-RC270 User Manual

78
En
If you want to control an Onkyo component by pointing
the remote controller directly at it, use the following
remote control codes:
` 32900:
Onkyo Blu-ray Disc player
` 32901:
Onkyo HD-DVD player
` 70868:
Onkyo MD recorder without u
` 71323:
Onkyo CD recorder without u
` 82990:
Onkyo Dock without u
Note
• If you connect a cassette tape deck to the TV/CD IN jack, or
connect an RI Dock to the to the TV/CD IN or VCR/DVR IN or
GAME IN jacks, for u to work properly, you must set the Input
Display accordingly (➔ 27).
You can reset a REMOTE MODE to its default remote
control code.
You can reset the remote controller to its default settings.
By pressing REMOTE MODE that’s been programmed
with the remote control code for your component, you can
control your component as below.
For details on entering a remote control code for other
components, see “Entering Remote Control Codes”
(➔ 77).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the p
*1
(limited to
some models). The TV must be able to receive remote
control commands via p and be connected to the
AV receiver via HDMI. If controlling your TV via
p doesn’t work very well, program your TV’s
remote control code into TV and use the TV remote mode
to control your TV.
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the p
*1
(limited to some models). The component must be able to
receive remote control commands via p and be
connected to the AV receiver via HDMI.
*1
The p supported by the AV receiver is the CEC
system control function of the HDMI standard.
Resetting REMOTE MODE Buttons
1
While holding down REMOTE MODE that you
want to reset, press and hold down HOME until
REMOTE MODE lights (about 3 seconds).
2
Within 30 seconds, press REMOTE MODE again.
REMOTE MODE flashes twice, indicating that the
button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.
Note
• The learning command is also reset.
Resetting the Remote Controller
1
While holding down RECEIVER, press and hold
down HOME until RECEIVER lights (about 3 sec-
onds).
2
Within 30 seconds, press RECEIVER again.
RECEIVER flashes twice, indicating that the
remote controller has been reset.
Controlling Other Components

Onkyo HT-RC270 Specifications

General

Brand	Onkyo
Model	HT-RC270
Category	Receiver
Language	English