EasyManuals Logo

Onkyo HT-S5910 User Manual

Onkyo HT-S5910
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
67
Front Panel Rear Panel Remote
Contents
Connections
Playback
Setup
audio output on the player to Bitstream output.
Full Mono
In this mode, all speakers output the same sound in mono, so the sound you hear
is the same regardless of where you are within the listening room.
Mono
In this mode, monaural audio is played from the center speaker at the time of
inputting an analog signal or PCM signal. If there is no center speaker connected,
monaural audio is played from the front speakers.
Multich (Multichannel)
This mode is suitable to play sources recorded in multichannel PCM.
Orchestra
This mode is suitable for classical or operatic music. This mode emphasizes the
surround channels in order to widen the sound image, and simulates the natural
reverberation of a large hall.
Stereo
In this mode, sound is output from the right and left front speakers and
subwoofer.
Studio-Mix
This mode is suitable for rock or pop music. This mode creates a lively sound
eld with a powerful acoustic image as if you are at a club or rock concert.
T-D (Theater-Dimensional)
In this mode, you can enjoy a virtual playback of multichannel surround sound
even with only two or three speakers. This works by controlling how sounds
reach the listener’s left and right ears.
This mode cannot be selected when "Speaker Virtualizer" ( p85) is set to
"Off" (Default: On).
TV Logic
Suitable for TV shows produced in a TV studio. This mode gives clarity to voices
by enhancing the entire surround sounds, and creates a realistic acoustic image.
Unplugged
Suitable for acoustic instruments, vocals and jazz. This mode emphasizes the
front sound eld image, giving the impression of being in front of the stage.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo HT-S5910 and is the answer not in the manual?

Onkyo HT-S5910 Specifications

General IconGeneral
Receiver typeSurround
Frequency range10 - 100000 Hz
Input sensitivity200 mV
4Ω speaker supportNo
Audio output channels5.1.2 channels
Total Harmonic Distortion (THD)0.08 %
Dynamic power per channel (3 Ohm)160 W
Power output per channel (20-20KHz@8 Ohm)115 W
DisplayLCD
Product colorBlack
Audio decodersDolby Atmos
Damping factor60
Amplifier output power925 W
HDMI in4
Composite video in3
Digital audio coaxial in1
Digital audio optical in2
Ethernet LAN (RJ-45) ports0
Audio (L/R) out7
Connectivity technologyWired
Speakers connectivity typeClamp terminals
Supported radio bandsAM, FM
AC input voltage120 V
AC input frequency60 Hz
Weight and Dimensions IconWeight and Dimensions
Depth328 mm
Width453 mm
Height160 mm
Weight7800 g

Related product manuals