20
En
• If your mobile phone supports A2DP protocol, its
music will play through the controller.
• If you press and hold the /TV input button on the
top panel or INPUT on the remote controller for
three seconds with Bluetooth selector selected, the
Bluetooth connection to the Bluetooth-enabled
device is interrupted and start the pairing.
• If there is no sound output even after the paring is
done successfully, consult the user manual of the
Bluetooth-enabled device, and then select the
“Onkyo LS3200” as the audio output device.
• The controller can store the pairing information of
up to 16 Bluetooth devices. If the pairing is done for
the 17th Bluetooth device, the pairing information
of device connected via Bluetooth in the most past
times is erased.
• For some Bluetooth-enabled devices, a pairing is
necessary for every reconnection.
• The multiple Bluetooth devices cannot be
connected at the same time.
Listening to an audio from
Bluetooth device
1
Press the /TV input button on the top
panel repeatedly or INPUT on the
remote controller until the Bluetooth
LED lights to select the Bluetooth
selector.
The controller searches the component
connected previous time and starts the
pairing in five seconds when the
corresponding item is not found.
• If you press the /TV input button on the top
panel or INPUT on the remote controller
again during pairing and switch the selector to
TV, the operation will be cancelled.
2
While the Bluetooth LED is flashing
quickly, you can operate the Bluetooth-
enabled device to pair with the
controller within a 32 ft. (10 m) range.
The pairing mode will be disabled in 25
seconds. When the mode is disabled, the
LED will flash slowly.
For details on the Bluetooth connection,
refer to the user manual of the Bluetooth-
enabled device.
The controller may not work as normal
depending on the circumstance even
though the controller is placed within the
32 ft. (10 m) range. In such cases, get the
Bluetooth-enabled device closer to the
controller and retry the operation.
3
Once the controller is detected and its
name “Onkyo LS3200” appears on the
display of your Bluetooth-enabled
device, select the “Onkyo LS3200”. If a
prompt requests a password (PIN code),
key in the “0000”.
When a Bluetooth connection is
established successfully, the Bluetooth
LED flashes twice, then lights.
4
Start playback on your device.
The controller automatically starts playing
the audio.
LS3200_En.book 20 ページ ２０１５年５月１３日 水曜日 午後５時５１分
To Next Page
