Onkyo LS3200 User Manual

8
En
Using the Remote Controller
Remove the plastic film before using the
remote controller.
To use the remote controller, point it at the
controller’s remote control sensor, as shown
below.
Replacing the Battery
Use only a battery of the same type (CR2025).
Note
• If the remote controller doesn’t work reliably, try
replacing the battery.
• If you intend not to use the remote controller for a
long time, remove the battery to prevent damage
from leakage or corrosion.
• Remove expired battery as soon as possible to
prevent damage from leakage or corrosion.
Caution
• Replacing the battery incorrectly may cause an
explosion. Use only a battery of the same type or an
equivalent.
(Placing on the floor, etc.)
LAP-302
Remote control
sensor
Approx.
16ft. (5m)
(Mounting to the wall)
LAP-302
Remote control
sensor
Approx.
16ft. (5m)
LAP-302
Remote control
sensor
Approx.
16ft. (5m)
Positive ⊕ side
Pull out firmly in the direction of the arrow
pressing the tab in the direction of the arrow.
Push
Pull
Back side
LS3200_En.book 8 ページ ２０１５年５月１３日 水曜日 午後５時５１分

Onkyo LS3200 Specifications

General

Brand	Onkyo
Model	LS3200
Category	Speaker System
Language	English