Onkyo NCP-302 User Manual

EN
20
∫ Initializing the unit (the settings are
initialized)
When you initialize, network settings and pairing
information will also be initialized, so we
recommend that you note down your settings
before initializing.
1 While the power is on, press ON/STANDBY
while pressing INPUT.
0 The indicators go out and the unit is
initialized.
∫ If the power goes off suddenly
The power may turn off suddenly when the
protection circuit in the unit functions. If this
occurs, unplug the power cord, then reconnect
and turn the unit on again. If the power turns of
repeatedly, unplug the power cord and contact
the place of purchase.
∫ When the power of other units cannot
be turned on with the app
To turn on Onkyo devices connected to the same
network as this unit using the app, you first need
to enable the network standby settings on those
devices.

Onkyo NCP-302 Specifications

General

Product color	Black
Volume control	Rotary
Recommended usage	Universal
Multi-Room Streaming (MRS) support	Yes
Speaker type	2-way
Woofer diameter	77 mm
Tweeter diameter	26 mm
Number of drivers	-
Speaker placement	Tabletop/bookshelf
Audio output channels	- channels
RMS rated power	- W
Signal-to-Noise Ratio (SNR)	75 dB
Total Harmonic Distortion (THD)	0.5 %
Package depth	206 mm
Package width	426 mm
Package height	262 mm
Package volume	3800 cm³
Connectivity technology	Wired & Wireless
Cables included	AC, AUX
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	10 W

Weight and Dimensions

Depth	106 mm
Width	320 mm
Height	172 mm
Weight	2600 g