12
> Before Start > Part Names > Install > Initial Setup >Playback
Supplementary information | Advanced Setup | Others
USB Storage Device/HDD
Playback
Basic operations
You can play music files by connecting a USB storage
device or HDD (hard disk drive) to the USB port on the front
or rear of the unit.
0 The USB port on the front supports a maximum 5 V/0.5 A
power supply. If the HDD requires more than this,
connect to the USB port (maximum 5 V/1 A) on the rear
of the unit.
1. Turn the unit on.
2. Press USB to select "USB (F)" (USB port on the front
panel) or "USB (R)" (USB port on the rear panel).
3. Plug your USB storage device or HDD into the USB port
on the front or rear.
4. Press ENTER (e) after reading is complete.
5. Select the folder or music file with / (d) on the
remote controller and press ENTER (e) to confirm. To
return to the previous display, press (f).
6. Use play buttons (b) to stop play or choose tracks to play.
0 The display of album name and artist name is supported
with MP3/WMA/Apple Lossless/FLAC/AAC/DSD (DSF
only) format music files.
0 Characters that cannot be displayed by this unit appear
as "
¢
".
0 The USB port of this unit conforms with the USB 2.0
standard. The transfer speed may be insufficient for
some content you play, which may cause some
interruption in sound.
Repeat play
1. Repeatedly press REPEAT (a) during play to display
or on the display.
: Repeat play of the selected individual track.
: Repeat play of all tracks within a folder.
To cancel repeat play, press REPEAT (a) several times
To Next Page
Loading...
Need help?
General
Weight and Dimensions
