27
Using the Timers
—Continued
Notes:
•You can change each setting while it’s displayed by
using the TUNING/PRESET [ ]/[ ] buttons
(TIMER [ ]/[ ]).
• If a timer is off when you change a setting, it will be
turned on.
• When you’ve checked all of the settings, if there are
no changes, the previous display reappears.
•You can return to the normal display at anytime by
pressing the [TIMER] button.
You can set the sleep timer so that it automatically turns
the system off after a specified period.
Setting with the Remote Controller
■
Checking the Remaining Sleep Time
To check how much time there is left until the system
turns off, press the [SLEEP] button. Note that if you
press the [SLEEP] button again while the remaining
sleep time is displayed, you’ll shorten the sleep time by
10 minutes.
■
Canceling the Sleep Timer
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator goes off.
Using the Sleep Timer
Press the [SLEEP] button repeat-
edly to set the sleep time.
The time decreases in 10-minute steps
each time the button is pressed (90, 80,
70, and so on).
Use the TIMER Up and Down
[ ]/[ ] buttons to adjust the sleep
timer in 1-minute steps. The Up [ ]
button increases the time in 1-minute
steps up to the maximum of 99 min-
utes. The Down [ ] button decreases
the time in 1-minute steps down to the
minimum of 1 minute.
The SLEEP indicator appears on the
display when the sleep timer has been
set. The specified sleep time is dis-
played for about 5 seconds, then the
previous display reappears.
To Next Page
Loading...
