Onkyo T3

7EN
4 Use Bluetooth
devices
With this speaker, you can listen to audio
from Bluetooth-enabled devices and control
the incoming call through Bluetooth.
Connect a Bluetooth-
enabled device
Note
•
Make sure that your Bluetooth device is compatible
with this speaker.
• Before pairing a device with this speaker, read its
user manual for Bluetooth compatibility.
• Make sure that Bluetooth function is enabled on
your device, and your device is set as visible to all
other Bluetooth devices.
• Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
• Keep away from any other electronic device that
may cause interference.
• The operational range between this speaker and
a Bluetooth device is approximately 10 meters (30
feet).
1 Make sure that the speaker is in pairing
mode.
» The power/Bluetooth indicator
flashes blue quickly.
» If the power/Bluetooth indicator
flashes blue slowly, press and hold
for two seconds to enter pairing
mode.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth
devices (refer to the user manual of the
device).
3 When [Onkyo T3] is displayed on your
device, select it to start pairing and
connection. If necessary, enter the
default password “0000”.
» After successful pairing and
connection, the speaker beeps, and
the power/Bluetooth indicator turns
solid blue.
To disconnect the Bluetooth-enabled
device:
• Press and hold
on the speaker for two
seconds;
• Disable Bluetooth on your device; or
• Move the device beyond the
communication range.
» The power/Bluetooth indicator
flashes blue.
To reconnect the Bluetooth-enabled device:
• Next time you turn on the speaker,
the speaker tries to reconnect the last
connected device automatically;
• If not, manually select "Onkyo T3"
on your Bluetooth device to start
connection.
Connect two Bluetooth
devices simultaneously
The speaker can connect to two Bluetooth
devices at the same time.
1 Connect one Bluetooth device (see the
above section "Connect a Bluetooth-
enabled device").
2 Press and hold for two seconds to
enter pairing mode.
» The LED indicator flashes blue
quickly, and the first device is
disconnected.
3 Connect the second Bluetooth device.