Onkyo TA-2130 User Manual

El
Troubleshooting guide
The
following
guide
lists
problems
which
do
not
require
professional
servicing.
If,
however,
the
problem
can
not
be
remedied
using
this
guide, contact your Onkyo dealer for assistance.
[rete
Te
@
Power
cord
plug
is
loose.
@
Insert
plug
properly
into
outlet.
-
|
@
Hook-up
incorrect.
@
Check
and
hook
up
correctly
according
to
page
2.
Playback but no sound.
@ Stereo amplifier input selector switch is @ Change switch position.
set to wrong position. .
Tape
does
not
move.
@
Slack
tape
wound
around
pinch
roller.
@
Take
up
slack
with
a
pencil
(see
page
6).
Recording key does not engage. @ No tape in cassette holder. @ Load cassette tape.
@ Erasure prevention tab(s) removed. @ Change cassette or cover tab hole with cellophane
tape.
Hoarse
sound,
balance
unstable.
|
@
Playback
head
dirty.
@
Clean
head
(see
page
6).
@
Tape
is
stretched.
@
Replace
cassette.
Excessive
noise
and
tape
hiss.
@
Head
has
become
magnetized.
@
Demagnetize
(see
page
6).
@
Tape
with
high
noise
level.
@
Replace
cassette.
Distorted
sound.
@
Distortion
in
tape.
®@
Tape
is
probably
bad
but
confirm
by
listening
to
another.
Recordings
are
distorted.
@
Recording
was
done
at
too
high
a
level.
|
@Readjust
Input
Recording
Level
Control
knob
according
to
the
directions
on
page
4.
Tape
squeal/skipping.
@
Dirty
head,
pinch
roller
or
capstan
@
Clean
(see
page
6).
shaft.
@ Cassette shell is binding tape or tape is
stretched.
@ Change cassette or try correcting with fast forward
and rewind.
Excessive hum during playback. @ Connecting cables not inserted firmly.
@ External flux leakage from nearby
amplifier.
High frequencies too strong. ® Dolby NR encoded tape played back @ Set the Dolby NR buttons to the proper position for
with NR off. the tape being played back.
@ Set the Dolby NR buttons to the proper position for
the tape being played back.
@ Clean (see page 6).
@ Insert plugs firmly.
@ Move deck away from hum source.
No high frequency sounds. @ Non-Dolby NR encoded tape played
back with Dolby B or C NR on.
@ Record/playback head has become
dirty.
@ Tape transport control microcomputer
has been exposed to interference (from
power supply or static electricity).
Deck does not operate properly. @ Switch power off for about ten seconds.
7

Onkyo TA-2130 Specifications

General

Brand	Onkyo
Model	TA-2130
Category	Tape Deck
Language	English