Various settings
33
It
De
Update procedures
1. Press the SETUP button.
2. Use the direction ( / ) buttons to select “6. Firmware
Update” and press the ENTER button.
0
If it is not displayed, wait for a moment until the
network feature starts.
3. Use the direction ( / ) buttons to select “Update via
NET” and press the ENTER button.
0
The option does not appear when no firmware
update is available.
4. Press the ENTER button with “Update” selected to
start update.
“Completed!” appears on the display when updating is
completed.
5. Press the
Í
ON/STANDBY button on the front panel
to put the unit into standby.
0
Do not use the
Í
button on the remote control for
this operation.
The update is complete. The unit’s firmware has been
updated to the latest version.
When an error message appears
When an error occurs, “*-** Error!” appears on the display
of this unit. (Characters and numbers appear in place of
the asterisks.) Refer to the descriptions below to check
the meaning.
Error code
*-01, *-10:
The Ethernet cable could not be
recognized. Connect the Ethernet cable properly.
*-02,*-03,*-04,*-05,*-06,*-11,*-13,*-14,*-16,*-17,*-18,
*-20,*-21:
Internet connection could not be
established. Check the following points.
- Whether the router is turned on
- Whether this unit and router are connected to the
network
Try to disconnect and then connect again the power to
the unit and router. This may solve the problem. If you
are still unable to connect to the Internet, the DNS
server or proxy server may be temporarily down.
Check the service status with your ISP provider.
Others:
Disconnect and reconnect the power cord,
and retry updating.
∫ Updating the firmware via USB connection
You need a 64 MB or larger capacity USB storage for
updating.
Update procedures
1. Connect a USB storage to the PC that you are using
and delete any files on it.
2. Download the firmware file to the PC from our website.
Decompress the downloaded file on the PC.The
number of unzipped files and folders varies depending
on the model.
3. Copy the decompressed files and folders to the root
folder of the USB storage.
0
Do not copy any files other than the decompressed
files. Do not copy the compressed file.
4. Press the NET button.
5. Use the direction ( / ) buttons to select “USB” on
the display and press the ENTER button.
6. Connect the USB storage with the decompressed files
to the USB port.
0
Loading the USB storage takes about 20 to 30
seconds.
7. Press the SETUP button.
8. Use the direction ( / ) buttons to select “6. Firmware
Update” and press the ENTER button.
0
If it is not displayed, wait for a moment until the
network feature starts.
9. Use the direction ( / ) buttons to select “Update via
USB” and press the ENTER button.
0
The option does not appear when no firmware
update is available.
Precautions when updating the firmware
0 Before updating, stop playback and disconnect
anything connected to the USB port.
0 While updating, never put the unit into standby
mode, or disconnect the power cord or the USB
storage being used for the update.
0 Do not access this unit from a PC while updating.
0 Updating takes about 30 minutes to be completed.
0 Settings you made are retained after updating.
TX-8130_mst.book 33 ページ ２０１５年１１月２日 月曜日 午後１時１６分
To Next Page
Loading...
