121
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
5. Works with SONOS
Change the settings to connect with the Sonos Connect.
Setting Item Default Value Setting Details
Input Selector O Select the input selector to which the Sonos
Connect is connected.
• Selecting "O" disables the interlock function
with Sonos.
Connected Device - Displays the Sonos Connect connected to the
same network as the network of this unit. Press
the ENTER button to select the connected Sonos
Connect.
• Products (e.g. Play:3 unequipped with an output
terminal) other than the Sonos Connect are also
displayed in the device list and selectable. In that
case, when playback on the Sonos side starts,
the input is switched, however, audio is not
output. Select the room name of the connected
Sonos Connect.
• Up to 32 devices can be displayed on the Sonos
product list screen. If you cannot nd the Sonos
Connect to be interlocked, return to the previous
screen, turn o the product you want to interlock,
and try again.
• To use this function, set "Input Selector"
beforehand.
Output Zone Main Select the zone where you want to listen to the
music.
"Main": Outputs audio only to the main room
(where this unit is located).
"Zone 2": Outputs audio only to the separate room
(ZONE 2).
"Main/Zone 2": Outputs audio to both the main
room and separate room.
• To use this function, set "Input Selector"
beforehand.
Setting Item Default Value Setting Details
Preset Volume Main:
Last
Zone 2:
Last
You can set the volume beforehand for playing
back the Sonos Connect. You can set volumes
for the main room (where this unit is located) and
separate room (ZONE 2) respectively. Select a
value from "Last" (Volume level before entering
standby mode), "Min", "1" to "99" and "Max".
• To use this function, set "Input Selector"
beforehand.
To Next Page
Loading...
Need help?
General
