Onkyo TX-NR595 - Page 77

77
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
ZONE B Playback
While performing playback through speakers (ZONE A) connected to the unit, you can enjoy the audio of the same source with the pre-main amplier (ZONE B)
connected to the ZONE B LINE OUT jack at the same time.
Playing Back
1. Press the Q button on the remote controller to select "Other" - "Zone B".
• When ZONE 2 is On, "Zone B" cannot be selected.
2. Select an audio output destination.
O󰀨: Outputs audio only to ZONE A. "A" on the display of the main unit lights
up.
On(A+B): Outputs audio to both ZONE A and ZONE B. "A" and "B" on the
display of the main unit light up.
On(B): Outputs audio only to ZONE B. "B" on the display of the main unit
lights up.
3. Start play on the AV component.
4. Adjust the volume on the pre-main amplier for ZONE B.
If "On (A+B)" is selected as an audio output destination, you can select only the
"Stereo" listening mode for ZONE A when using the 2.1ch speaker layout. When
using a speaker layout of 3.1ch or more, you can select only the "AllCh Stereo"
listening mode.