Advanced Settings
29
Setting item Default Value Setting Details
Back 7.0ft/2.10m Specify the distance between each speaker and
the listening position.
r The setting is displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back ch" is set to "1ch".
r This setting cannot be changed when "Speaker
Settings" - "Powered Zone 2" is set to "Yes"
and Zone 2 is turned on.
Surround Left 7.0ft/2.10m Specify the distance between each speaker and
the listening position.
Subwoofer 12.0ft/3.60m Specify the distance between each speaker and
the listening position.
Height Left 9.0ft/2.70m Specify the distance between each speaker and
the listening position.
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height Speakers
Type" is set to "Not Use".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes" and also Zone2 is set to on.
Height Right 9.0ft/2.70m Specify the distance between each speaker and
the listening position.
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height Speakers
Type" is set to "Not Use".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes" and also Zone2 is set to on.
r When the speaker is set to "No" or "None" in "Speaker Configuration", the settings for "Speaker
Distance" cannot be changed:
r Default values vary depending on the regions.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting item Default Value Setting Details
Front Left 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Center 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Front Right 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Surround Right 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
Back Right 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
r The setting is not displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back ch" is set to "1ch".
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Front Speakers
Type" is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes" and also Zone2 is set to on.
Back Left 0dB Select a value between "-12dB" to "+12dB". A
test tone will be output each time you change
the value. Select the desired level.
r The setting is not displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back ch" is set to "1ch".
r This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Front Speakers
Type" is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes" and also Zone2 is set to on.
To Next Page
Loading...
