Onkyo TX-NR828 - Remote Controller; Operating the AV Receiver

Safety Information and Introduction
En-12
Remote Controller
To control the AV receiver, press RECEIVER to
select Receiver mode.
For detailed information, see the pages in
parentheses.
a 8 RECEIVER button (24)
b ACTIVITIES buttons (54, 90)
c REMOTE MODE/INPUT SELECTOR buttons
(32)
d SP (speaker layout) button (53)
e q/w/e/r and ENTER buttons
f Q SETUP button (56)
g Listening Mode buttons (44)
h DIMMER button (52)
i DISPLAY button (52)
j MUTING button (53)
k VOL q/w button (32)
l RETURN button
m HOME button (55)
n SLEEP button (52)
Tip
• You can also use the remote controller to control Onkyo
Blu-ray Disc/DVD player, CD player, and other
components.
See “Entering Remote Control Codes” for more details
(➔ page 82).
■ Controlling the tuner
To control the AV receiver’s tuner, press TUNER (or
RECEIVER).
You can select AM or FM by pressing TUNER
repeatedly.
a q/w buttons (41)
b D.TUN button (41)
c DISPLAY button
d CH +/– button (42)
e Number buttons (41)
*1
When you want to change the remote controller mode
(target component) without changing the current input
source, press MODE and within about 8 seconds, press
REMOTE MODE. Then, using the same AV receiver’s
remote controller, you can control the component
corresponding to the button you pressed.
*2
These buttons can also be used when a REMOTE
MODE other than Receiver mode is selected.
Controlling the AV Receiver
n
e
h
b
d
f
g
e
a
j
k
d
l
m
c
b
a
c
i

*1
*2
*2
*2
*2
RECEIVER