127
Controlling Other Components
—Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via , use
the following remote control codes:
•[DVD] REMOTE MODE button
5001:
Onkyo DVD player without (default)
• [CD] REMOTE MODE button
6001:
Onkyo CD player without (default)
• [MD] REMOTE MODE button
6007:
Onkyo MD recorder without
• [CDR] REMOTE MODE button
6005:
Onkyo CD recorder without
• [DOCK] REMOTE MODE button
6003:
Onkyo RI Dock without
Note:
• If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TAPE
IN/OUT jacks, or connect an RI Dock to the
GAME/TV jacks, for to work properly, you must
set the Input Display accordingly (see page 57).
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
1
Make sure the Onkyo component is con-
nected with an cable and an analog
audio cable (RCA).
See page 49 for details.
2
Enter the appropriate remote control code
to the REMOTE MODE button.
•[DVD] REMOTE MODE button
5002:
Onkyo DVD player with
• [CD] REMOTE MODE button
6002:
Onkyo CD player with
• [MD] REMOTE MODE button
6008:
Onkyo MD recorder with
• [CDR] REMOTE MODE button
6006:
Onkyo CD recorder with
• [DOCK] REMOTE MODE button
6004:
Onkyo RI Dock with
See the previous page for how to enter remote
control codes.
3
Press the REMOTE MODE button, point
the remote controller at the AV receiver,
and operate the component.
1
While holding down the REMOTE
MODE button that you want to
reset, press the TV [ ] button.
The Remote indicator flashes three
times.
2
Press the REMOTE MODE button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers, respectively. When these buttons
are reset, the preprogrammed codes are
restored.
Resetting the Remote Controller
1
While holding down the
[RECEIVER] REMOTE MODE but-
ton, press the [STANDBY] button.
The Remote indicator flashes five
times.
2
Press the [RECEIVER] REMOTE
MODE button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
SAT
REMOTE MODE
TV
VCR
CABLE
DVD
CDR/MD/DOCK
CD
SAT
REMOTE MODE
TV
VCR
CABLE
DVD
CDR/MD/DOCK
CD
RECEIVER
STANDBY
RECEIVER
TX-NR905En.book Page 127 Wednesday, January 23, 2008 1:36 PM
To Next Page
Loading...
