14
Getting to Know the AV Receiver
—Continued
c
MULTI CH input: FRONT L/R, CENTER,
SUBWOOFER, SURR L/R, and SURR BACK
L/R
This analog multichannel input is for connecting a
component with a 5.1/7.1-channel analog audio out-
put, such as a DVD player, DVD-Audio or
SACD-capable player, or an MPEG decoder.
d
PRE OUT: FRONT L/R, CENTER, SUB-
WOOFER, SURR L/R, and SURR BACK L/R
This 5.1/7.1 multichannel analog audio output can
be connected to the analog audio input on a multi-
channel power amplifier for when you want to use
the AV receiver solely as a preamplifier. The SUB-
WOOFER jack is for connecting a powered sub-
woofer.
e
PRE OUT: ZONE 2, ZONE 3
These analog audio outputs can be connected to the
line inputs on amplifiers in Zone 2 and Zone 3.
f
ZONE 2 L/R SPEAKERS
These terminal posts are for connecting speakers in
Zone 2 or front Speakers B.
The ZONE 2 L/R and SURR BACK L/R terminal
posts can be used with front Speakers B and sur-
round back speakers, respectively, or used to bi-amp
or bridge front Speakers B. See “Bi-amping Front
Speakers A” and “Bridging Front Speakers A” on
page 28.
g
AC OUTLET (North American and European
models only)
These switched AC outlets can be used to supply
power to other AV components. The type and num-
ber of outlets depends on the country in which you
purchased your AV receiver.
See pages 22–49 for hookup information.
TX-NR905En.book Page 14 Wednesday, January 23, 2008 1:36 PM
To Next Page
Loading...
