Onkyo TX-SV828THX - Initialize; Initialize of System Setup When Operating with the Main Unit; Initialize of Surround Setup When Operating with the Main Unit; When Operating with the Cursor on the Screen

55 pages

To Next Page

To Previous Page

Main Page

Contents1
Features2
For European Model2
For USA Model2
For Canadian Model2
Important Safeguards3
Example of Antenna Grounding3
Precautions4
Supplied Accessories4
Memory Preservation4
Explanation5
Surround System5
Multiple Room Remote System (MRX)5
Dolby Pro Logic Surround5
Before Using this Unit6
Using the Remote Control6
Inserting the Batteries into the Remote Control6
Speaker Placement7
Placing the Speakers for Surround Effects7
Placing a Subwoofer Speaker7
THX Speaker System7
Control Positions and Names8
Front Panel8
Display8
Universal Programmable Remote Control (RC-307M)9
Audio Equipment Connections10
Remote Control Connections10
AC Outlet Connections10
Video Equipment Connections11
Video-4/Camcorder11
S-Video Terminals12
Video Input/Output12
Speaker Connections13
Connecting the Front and Surround Speakers13
Connecting the Speaker Cables13
Connecting of Center Speaker and Subwoofer13
Antenna Connections14
Connecting the Antenna Cable14
Assembling the am Loop Antenna14
Connecting the Coaxial Cable to the 75/300 Ohms Adaptor (Only Worldwide Models)14
Connecting the T-Shaped FM Antenna and the am Loop Antenna15
Connecting an am Outdoor Antenna15
Connecting an FM Outdoor Antenna15
Optional Amplifier Connections16
Remove the Jumper16
Optional Power Amplifier Connections16
Optional Pre-Amplifier Connections17
AC-3 Decoder Connections17
Connection for Multi-Room Remote Control18
Operating Components Displaying Onkyo's RI Mark from the Sub-Room (USA and Canadian Models)18
Using a Remote Control to Operate Components Not Displaying Onkyo's RI Mark from the Sub-Room (USA and Canadian Models)18
Operating Components Displaying Onkyo's RI Mark from the Sub-Room (Models Other than USA and Canadian Models)19
Using a Remote Control to Operate Components Not Displaying Onkyo's RI Mark from the Sub-Room (Models Other than USA and Canadian Models)19
Connection Diagram19
Learning Remote Control Codes20
Universal Programmable Remote Control RC-307M20
"Learning" New Controller Codes20
Operating the Remote Control21
Changing Commands21
How to Reset the RC-307M (Clearing All Memorized Command)21
If the Indicators Flash21
Using the On-Screen Display Function (Done Entirely with the Remote Control)22
Switching between the NTSC and PAL Systems22
On-Screen Display22
Using the Menu Screen22
The Screen Changes as Follows23
Screen Setup Menu23
Basic Operation23
Listening to Your Favourite Source24
Variable Loudness Control24
Tone Defeat Control24
Using Headphone25
Explanation of the Buttons26
TX-SV828THX Parameter27
System Setup (for All Surround Models)28
System Setup Menu28
Setting System Setup a28
Turn on System Setup28
Speakers a or B29
Center Speaker Mode29
Operating with the Cursor on the Screen Using the Remote Control29
Subwoofer30
Low/High Pass Filter30
Delay Time30
Level Calibration (Test Tone) for All Models31
Operating the Test Tone Using the Main Unit31
Operating the Test Tone Using the Cursor on the Screen31
Operating the Test Tone Using the Test Tone Button on the Remote Control31
Initialize32
Initialize of System Setup When Operating with the Main Unit32
Initialize of Surround Setup When Operating with the Main Unit32
When Operating with the Cursor on the Screen32
Using the Tuner33
Tuning the Radio (Manual Tuning and Direct Tuning)33
Listening to a Stereo Radio Station (FM Only)33
Using Preset Stations34
Selecting Preset Stations34
Cancelling Preset Stations34
Receiving RDS (European Model Only)35
What Is RDS?35
PTY Classifications in Europe35
How to Search for a Station Which Broadcasts Your Favorite Category (PTY Scan)36
Receiving RDS Traffic Information36
Displaying Radio Text (RT)36
Entering Station Names37
Entering New Characters37
Clearing All of the Characters Stored in Memory37
Changing Existing Characters37
Recording a Source38
Recording an Audio Source38
Recording and Dubbing to a Tape Deck Connected to Tape-138
Recording and Dubbing to a Tape Deck Connected to Tape-239
Using the Graphic Equalizer39
VCR Recording40
Recording to Video-2 and Video-340
Playback and Recording of TV Picture and Fm/Cable TV Sound41
Mixing Video and Audio for VCR Recording41
Using the Surround Modes (Basic Operation of Surround Modes)42
Operating Surround42
Using the Surround Modes (Using the Dolby Pro Logic Surround Mode)43
Dolby Pro Logic43
Using the Surround Modes (Using the Home THX Cinema Surround Mode)44
Using the Surround Modes (Using the Theater Surround Mode)45
Using the Surround Modes (Using the Hall, Live, Arena and Studio Surround Modes)46
Using the Surround Modes (Using the External Decoder Mode)47
Using the Surround Modes (Using the Monaural Source with the By-Pass Mode)48
Using the Surround Modes (Explanations)49
Explanation 1: Surround Speakers Image49
Explanation 2: Theater Size, Hall Size49
Explanation 3: Effect Level, Reverb Level and Reverb Time50
Explanation 4: Hall Shape50
Explanation 5: Stereo/Mono50
Explanation 6: Academy Filter50
Multi-Room Remote Control51
Listening to Devices Connected to the TX-SV828THX in Another Room51
If the Remote Controller Is Used from the Sub-Room, but the Components Cannot be Controlled, Check the Following...51
Troubleshooting Guide52
Specifications54

Onkyo TX-SV828THX - Initialize; Initialize of System Setup When Operating with the Main Unit; Initialize of Surround Setup When Operating with the Main Unit; When Operating with the Cursor on the Screen

Table of Contents

Related product manuals