17
BATTERY CHARGING
Note: To prolong the life of the battery and ensure the optimum eciency of the machine, the battery
must be charged after the use time of the machine exceeds 30min. Please do not allow the battery to re-
main uncharged for long.
The following charging instructions are suitable for the charger. Please ensure to use the charger provided
with the machine to avoid battery damage. The specication of the battery charger:
1. Move the machine to the place with good ventilation for charging.
2. Stop and place the machine on the level ground and turn the key to the close position.
3. When charging, tilt back and leave open the waste water tank to facilitate ventilation.
4. Plug the AC (alternating current) power cord of the charger to the power socket with sound grounding.
5. Unplug battery from machine. Plug the red DC (direct current) power cord of the charger to the battery
charging socket located in the battery compartment of the machine.
6. The charger will automat-
ically start charging and will
automatically switch o
when charging is complete
and the batteries are fully
charged.
Hint: The machine will not
work when being connected
to the charger.
Note: during the charging of the batteries, please do not pull the DC cord of the charger out of the socket
of the machine to avoid generation of arc strike. If the charging must be suspended during the charging,
please pull out the AC power cord rst.
• Charger type: - charger for aluminum acid battery
• Output voltage - 24V
• Output current - 15A
• Suitable for deep cycle battery charging
• APO circuit
WARNING: Fire or explosion hazard: The battery releases hydrogen. Please be away
from spark or open re. The battery cabin must be kept open when charging.
FOR SAFETY: Please wear protective gloves and eye protectors when treating the battery and battery
wiring when repairing the machine. Avoid contacting the battery acid. When charging, please open the side
of the wastewater tank to facilitate ventilation.
To Next Page
Loading...
