Onyx RX32 - User Manual

Questions and Answers

C
cordovasarahAug 12, 2025
Why is the waste water recovery rate low on my Onyx RX32?
- R
  Robin ScottAug 12, 2025
  A low waste water recovery rate in your Onyx Scrubber may be due to: * **Full Tank:** The waste water tank might be full; drain it. * **Worn Tape:** The water-absorbing adhesive tape could be worn; replace it. * **Blocked Pipe:** The water suction pipe may be blocked; remove any scraps. * **Damaged Seal:** The sealing strip of the waste water tank could be damaged; replace the sealing stripe.
J
Jordan JonesAug 19, 2025
What to do if the brush motor does not work on my Onyx RX32 Scrubber?
- F
  Felicia MorrisonAug 19, 2025
  If the brush motor on your Onyx Scrubber isn't working, consider the following: * **Brush Head Position:** Ensure the brush head is lowered to the ground. * **Battery Status:** If the battery coulomb-meter is locked, charge the battery. * **Breaker Issue:** Check if the breaker of the brush motor circuit has tripped; if so, reset it.
P
paguirreAug 27, 2025
How to fix little or no water flowing out of my Onyx RX32 Scrubber?
- C
  cmyersAug 27, 2025
  If little to no water is flowing from your Onyx Scrubber, check these: * **Filter/Pipe Blockage:** The filter or solution pipe of the clean water tank might be blocked; clean the filter. * **Flow Control Knob:** The speed setting on the flow control knob could be too low; adjust the water control knob. * **Loose Knob Screw:** The screw of the control knob might be loosened; lubricate the knob and then fasten the screw.
S
Sarah ScottSep 3, 2025
Why won't my Onyx Scrubber vacuum motor work?
- S
  Stephanie WilliamsSep 3, 2025
  If the vacuum motor on your Onyx Scrubber isn't working, check the following: * **Squeegee Position:** Ensure the squeegee is lowered to the ground. * **Fuse:** The fuse of the vacuum motor might be blown; replace it.