20
5. Load the machine using a ramp that can support the machine weight and driver (assume combined
weight of 1,000lbs)
6. Position the front of machine up against the front of the trailer or truck. Select brush and vacuum mode
of the Yellow mode switch on the main dash. This will lower the pad/brush head and squeegee.
7. Drive the scrubber onto the lift gate of the truck and position for transportation.
8. Set the parking brake, if equipped, and place a block behind each wheel to prevent the machine from
rolling.
9. Secure with tie-down straps. It may be necessary to install tie-down brackets to trailer or truck.
Note: Do not let the machine be subject to rain, excessive amounts of humidity and moisture, and store
indoor.
1. Please charge the battery before storage.
2. Yellow mode switch to OFF position, this will place pad/brush head and squeegee in up position.
3. Switch power key to OFF position.
4. Disconnect the batteries before any long-term storage.
5. Drain and ush thoroughly the bottom of the water tank.
6. Store the machine in a dry place.
7. Open the cover of the waste water tank.
8. Note: Do not let the machine be subject to rain, excessive amounts of humidity and moisture, and store
indoor.
9. If the machine is stored in a cold environment, drain all liquid in the machine.
MACHINE MAINTENANCE
MACHINE STORAGE
To Next Page
Loading...
Need help?
General
