Oontz Angle 3 Pro - Using a 3.5 mm Stereo Audio Cable

Page 13
- Plug one end of the included 3.5mm Stereo Audio Cable into the
AUX IN jack on the speaker.
- Press the Source Button and the Source Button light will turn
solid Green.
- Plug the other end of that 3.5mm Stereo Audio Cable into the
headphone jack on your device.
- Make sure both ends of the cable are fully inserted
- You are now ready to play.
Important: The Bluetooth on the OontZ Angle 3 Pro is disabled when the Source Button is pressed. To switch back to Bluetooth press
the Source Button and the OontZ Angle 3 Pro allows the last device it was connected to automatically reconnect with the speaker
and
that device is within range.
Important Notes:
- Note: The rubber flap needs to be closed before the speaker is exposed to water. The speaker is not water-resistant or
waterproof when the flap is open.
- The volume control on your device and the speaker work independently of each other. To play the speaker at the loudest volume,
set the volume on your device to maximum and raise the volume on the speaker to maximum.
Turn ON your OontZ Angle 3 Pro
To Play with Non-Bluetooth Devices Use the 3.5mm Stereo Audio Cable