Opt PD3000-RGB - Safety Notes

WARNING! This projector is a Class 4 laser product. It must never be used for audience-scanning
applicaons. The output beam of the projector must always be at least 3 meters above the floor in the
audience. See the Operang Instrucons secon for further informaon.
Please read the following notes carefully! They include important safety informaon about the
installaon, usage, and maintenance of this product.
SAFETY NOTES
Keep this User Manual for future consultaon. If you sell this product to another user, be sure that they also receive
this document.
Always make sure that the voltage of the outlet to which you are connecng this product is within the range stated on
the decal or rear panel of the product.
This product is not designed for use outdoors in adverse weather condions. To prevent risk of fire or shock, do not
expose this product to rain or moisture.
Always disconnect this product from the power source before cleaning it or replacing the fuse.
Make sure to replace the fuse with another of the same type and rang.
If mounng it overhead, always secure this product to a fastening device using a safety chain or cable.
In the event of a serious operang problem, stop using the projector immediately. Never try to repair the unit except in
a controlled environment under trained supervision. Repairs carried out by unskilled people can lead to damage or
malfuncon of the unit, as well as exposure to dangerous laser light.
Never connect this product to a dimmer pack.
Make sure the power cord is not crimped or damaged.
Never disconnect the power cord by pulling or tugging on the cord.
Never carry a product from the power cord or any moving part. Always use the hanging/mounng bracket or the
handles.
Always avoid eye or skin exposure to direct or scaered light from this product.
Lasers can be hazardous and have unique safety consideraons. Permanent eye injury and blindness is possible if lasers
are used incorrectly. Pay close aenon to each safety REMARK and WARNING statement in this user manual. Read all
instrucons carefully BEFORE operang this device.
Never intenonally expose yourself or others to direct laser light.
This laser product can potenally cause instant eye injury or blindness if laser light directly strikes the eyes.
It is illegal and dangerous to shine this laser into audience areas, where the audience or other personnel could get direct
laser beams or bright reflecons into their eyes.
It is a US Federal offense to shine any laser at aircra.
No service allowed by customer. There are no user serviceable parts inside the unit. Do not aempt any repairs
yourself.
Service is only to be handled by the factory or authorized factory trained technicians.
Product is not to be modified by the customer.
Cauon – use of controls or adjustments or performance of procedures other than those specified herein may result
in hazardous radiaon exposure.
3