Stainless steel cable(safety rope)
PROPER USAGE
This product is for overhead mounng only. For safety purposes, this projector should be mounted on
steady elevated plaorms or sturdy overhead supports using suitable hanging clamps. In all cases, you must
use safety cables.
Internaonal laser safety regulaons require that laser products must be operated in the fashion illustrated
below, with a minimum of 3 meters (9.8 .) of vercal separaon between the floor and the lowest laser
light vercally. Addionally, 2.5 meters of horizontal separaon is required between laser light and
audience or other public spaces.
The audience area can be passively protected by sliding the aperture cover plate upwards and fixing it in
proper posion by the two thumb screws.
RIGGING
3 meters
laser beams
Be sure that the structure onto which you are mounng this product can support its weight.
Mount the product securely. You can do this with a screw, a nut, and a bolt. You may also use a mounng clamp if
rigging this product onto a truss. The U-shaped support bracket has three mounng holes which may be used to
secure the clamps to the projector.
Always consider ease of access to the unit before deciding on a locaon for this product
When mounng this product overhead, always use a safety cable.
7
To Next Page
Loading...