EasyManua.ls Logo

Optex THERMO-HUNTER BUILT-IN - User Manual

Optex THERMO-HUNTER BUILT-IN
22 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
THERMO-HUNTER BUILT-IN
CS-30TAC
，
CS-40TAC
CS-30TAC-HT
，
CS-40TAC-HT
Non-Contact Thermometer
Printed in JAPAN 1941-4 2013/09
Instruction Manual
OPTEX FA CO., LTD.
91 Chudoji-Awata-cho Shimogyo-ku Kyoto
600-8815 JAPAN
TEL: +81-75-325-1314 FAX: +81-75-325-2936

Table of Contents

Questions and Answers

  • P
    Peter AndersonAug 11, 2025
    Why is the measurement value wrong on my Optex Thermometer?
    • B
      Brian KleinAug 12, 2025
      If the measurement value of your Optex Thermometer is incorrect, several factors could be the cause. First, a dirty lens can distort readings, so clean the lens according to the maintenance instructions. Second, ensure that the measurement area is correctly aligned; adjust the mounting position to center the target. Third, nearby high-temperature objects can interfere with readings; use a board or similar item to block the heat source. Finally, verify that the emissivity rate setting matches the target material.
  • L
    Lynn DanielsAug 22, 2025
    What to do if my Optex Thermometer cannot measure?
    • U
      urussellAug 22, 2025
      If your Optex Thermometer is not measuring, start by checking the cabling and connections to ensure they are secure. Then, verify that the power voltage is within the correct range, adjusting it to 12 to 24 VDC if necessary.
  • T
    Troy CrawfordAug 30, 2025
    How to stabilize the measurement value on an Optex Thermometer?
    • D
      Donald FitzgeraldAug 31, 2025
      If the measurement value of your Optex Thermometer is unstable, it could be due to vibration affecting the sensor head. Try to prevent any vibration. Alternatively, rapid temperature changes affecting the sensor head may also cause instability. In this case, allow the sensor head to sit for a while until its temperature stabilizes.

Optex THERMO-HUNTER BUILT-IN Specifications

General IconGeneral
Distance to Spot Ratio12:1
Resolution0.1°C
Laser MarkerSingle laser
Spectral Response8 to 14 µm
Storage Temperature-20°C to 60°C