Bossed Push On Effect Wheels
For this projector Optikinetics recommend that customers use
magnetic wheels. The Aura does also allow the use of bossed push on
wheels. To use these wheels you will be required to remove the
magnetic adapter from the projector. To do this, use the small allen key
provided and place this in the hole on top of the magnetic adapter.
Twist the allen key anticlockwise and the adapter will loosen and
detatch from the projector.
You may have to turn on the projector
to move the rotator. The hole on the
top of the magnetic adaptor must
face the top of the projector.
To reattach the magnetic adapter, make sure that the at of the shaft is
facing the top of the projector. Place the magnetic adaptor onto the
shaft and twist the allen key clockwise in the hole on the magnetic
adaptor. The adaptor will subsequently tighten and attach to the
projector.
Note:
4
Designed and Manufactured in the UK by Optikinetics
Aura
To Next Page
Loading...
Need help?
General
