Optium Xceed - Error E-6: Calibration;Electrode Error; Error E-7: Electrode Recognition Failure

What It What You Message
Means Need to Do
75
Calibration/
Electrode error.
Electrode error.
Electrode is
damaged, used,
or the monitor
does not
recognize it.
•Repeat the
calibration
using the
calibrator bar
that came with
the electrode
you are using.
•Check the date
setting on your
monitor.
•Check the
expiration date
on the
electrode foil
packet.
•If the error
message
appears again,
contact
Customer Service.
•Monitor again
using an
electrode
designed for
use with
Optium Xceed.
•If the error
message
appears again,
contact
Customer Service.
Error Messages
133-221 Manual,G3b,Aus 3/17/05 11:15 AM Page 78