To Next Page
H
Hannah BrownAug 10, 2025
What to do if Optoma EX610ST shows Error (Over Temp.)?
- MMichael ShafferAug 10, 2025
If your Optoma Projector displays an 'Error (Over Temp.)' message, turn off the projector and allow it to cool down.
What to do if Optoma EX610ST shows Error (Over Temp.)?
If your Optoma Projector displays an 'Error (Over Temp.)' message, turn off the projector and allow it to cool down.
What to do if Optoma EX610ST shows Error (Fan fail)?
If your Optoma Projector displays 'Error (Fan fail)', check the fan for any blockages and make sure that it is working as it should.
How to fix Optoma Projector Error (Lamp fail)?
To fix the 'Error (Lamp fail)' on your Optoma Projector, replace the lamp.
General| Brightness | 3000 ANSI Lumens |
|---|---|
| Resolution | XGA (1024x768) |
| Contrast Ratio | 3000:1 |
| Display Technology | DLP |
| Lamp Life | 4000 hours (Normal mode) |
| Zoom Ratio | 1.2x |
| Keystone Correction | ±40° vertical |
| Lamp Type | 190W |
| Inputs | VGA, S-Video, Composite Video |
| Outputs | Audio Out |
Explains the meaning of different LED status indicators for projector troubleshooting.
Outlines main troubleshooting procedures for common issues like auto shut down and 3D image abnormalities.
Guides users on how to enter and exit the projector's service mode.
Provides steps for performing auto keystone calibration to ensure a geometrically correct image.
Lists the necessary software and hardware for upgrading the projector's system firmware.
Details the required software and hardware for performing a PIC firmware upgrade using an RS-232 connection.
Provides instructions and requirements for upgrading the projector's firmware via the network connection.
