English
19
USING THE PROJECTOR
Powering off
Turn off the projector by pressing the 1. " " button on the projector keypad or the “ ” button on the
remote control.
The following message will be displayed:2.
Power Off?
Press Power key again
Press the 3. " " button on the projector keypad or the “ ” button on the remote control again to conrm,
otherwise the message will disappear after 15 seconds. When you press the " " or “ ” button for the
second time, the projector will shut down.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/4.
Standby LED will ash green or blue. When the On/Standby LED turns solid red, this indicates the
projector has entered standby mode. If you wish to turn the projector back on, you must wait until
the cooling cycle has nished and the projector has entered standby mode. When the projector is in
standby mode, simply press the " " button again to turn on the projector.
Disconnect the power lead from the electrical outlet and the projector.5.
It is not recommended that the projector is turned on immediately, right after a power off procedure.Note:
To Next Page
Loading...
