English
20
USING THE PROJECTOR
[Select Power Mode] [Select OTA Sever ]
[Agreement]
Powering o
1. Turn o the projector by pressing the “ ” button on the projector keypad or the remote control.
2. The following message will be displayed:
Power O
Please press power again
3. Press the “ button again to conrm, otherwise the message will disappear after 15 seconds. When
you press the “ ” button for the second time, the projector will shut down.
4. The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/
Standby LED will ash green or ash blue. When the On/Standby LED turns solid red, this indicates
the projector has entered standby mode. If you wish to turn the projector back on, you must wait until
the cooling cycle has nished and the projector has entered standby mode. When the projector is in
standby mode, simply press the “ ” button again to turn on the projector.
5. Disconnect the power lead from the electrical outlet and the projector.
Note: It is not recommended that the projector is turned on immediately, right after a power o procedure.
To Next Page
Loading...
Need help?
General
