Optoma UHD380x User Manual

English
66
ADDITIONAL INFORMATION
Warning indicators
When the warning indicators (see below) light up or ash, the projector will automatically shutdown:
 "LAMP" LED indicator is lit red and if "On/Standby" indicator ashes red.
 "TEMP" LED indicator is lit red and if "On/Standby" indicator ashes red. This indicates the projector
has overheated. Under normal conditions, the project can be switched back on.
 "TEMP" LED indicator ashes red and if "On/Standby" indicator ashes red.
Unplug the power cord from the projector, wait for 30 seconds and try again. If the warning indicator light up or
ash, please contact your nearest service center for assistance.
LED lightning messages
Message
On/Standby LED Temp LED Lamp LED
(Red) (Blue) (Red) (Red)
Standby state
(Input power cord)
Steady light
Power on (Warming)
Flashing
(0.5 sec o󰀨 / 0.5 sec
on)
Power on and Lamp lighting Steady light
Power o󰀨 (Cooling)
Flashing
(0.5 sec o󰀨 / 0.5
sec on). Back to red
steady light when
cooling fan turns o󰀨.
Error (Lamp failure) Flashing Steady light
Error (Fan failure) Flashing Flashing
Error (Over temp.) Flashing Steady light
Standby State
(Burn in mode)
Flashing
Burn in (Warming) Flashing
Burn in (Cooling) Flashing
Burn in (Lamp lighting)
Flashing
(3 sec on / 1 sec o󰀨)
Burn in (Lamp o󰀨)
Flashing
(1 sec on / 3 sec o󰀨)

Optoma UHD380x Specifications

General

Brand	Optoma
Model	UHD380x
Category	Projector
Language	English