English
42
MAINTENANCE
Installing and cleaning the dust lter
Installing the dust lter
1
2
Note:
Dust lters are only required/supplied in the selected regions with excessive dust.
Dust lters are not required in the North American region.
Cleaning the dust lter
We recommend you to clean the dust lter every three months. Clean it more often if the projector is used in a
dusty environment.
Procedure:
1. Switch off the power to the projector by pressing the “ ” button on the projector keypad or the “ ”
button on the remote control.
2. Disconnect the power cord.
3. Pull the dust lter compartment to the side to remove it out from the right side of the projector. 1
4. Carefully remove the air lter. Then clean or replace the dust lter. 2
5. To install the dust lter, reverse the previous steps.
1
2
To Next Page
Loading...
