English
17
SETUP AND INSTALLATION
Effective range
Infra-Red (IR) remote control sensor is located on the front side and rear side of the projector. Ensure to hold the
remote control at an angle within 30 degrees perpendicular to the projector’s IR remote control sensor to function
correctly. The distance between the remote control and the sensor should not be longer than 7 meters (~ 23 feet).
Make sure that there are no obstacles between the remote control and the IR sensor on the projector
that might obstruct the infra-red beam.
Make sure the IR transmitter of the remote control is not being shined by sunlight or uorescent lamps
directly.
Please keep the remote controller away from uorescent lamps for over 2 meters or the remote
controller might become malfunction.
If the remote control is closed to Inverter-Type uorescent lamps, it might become ineffective from time
to time.
If the remote control and the projector are within a very short distance, the remote control might
become ineffective.
When you aim at the screen, the effective distance is less than 5 meters from the remote control to the
screen and reecting the IR beams back to the projector. However, the effective range might change
according to screens.
ON
OFF
Menu
VGA1
HDMI1
User2
Con trast
Asp ect ra tio
DB
Vol ume
Sou rce
Re- sync
User1
Bri ghtnes s
Key stone
Mut e
User3
Mod e
3D
Sle ep Tim er
Vol ume
HDMI2
VGA2
Video
YPbPr
ON
OFF
Menu
VGA1
HDMI1
User2
Con trast
Asp ect ra tio
DB
Vol ume
Sou rce
Re- sync
User1
Bri ghtnes s
Key stone
Mut e
User3
Mod e
3D
Sle ep Tim er
Vol ume
HDMI2
VGA2
Video
YPbPr
Approx. ±15°
Approx. ±15°