Unit Settings [MSPlus/ MSPro]
With the MODE button you can select the
different setting functions. The unit must be in
the HOLD mode. The respective function will be
flashing in the display. With the U
P and DOWN
buttons you can change parameters or activate/
deactivate functions.
To save the settings you have to press the
MODE button again (will also switch to the next
function) or the T
RIGGER.
If you have not activated any button for 7
seconds, the instrument will not save the current
modification and shut down.
E
MISSIVITY
Definition ► see Unit Setting MS
The measurement of metallic surfaces, in
particular, requires a careful emissivity
adjustment. You will find a material table in
chapter Emissivity Tables.
Setting the emissivity: Press the MODE button
(during HOLD mode) – with U
P and DOWN you
can adjust the value. The shown temperature
value corresponds to the emissivity adjustment.
This allows a correction of even after the
measurement has been done.
optris MS – DE2011-04-A
29
To Next Page
Loading...
Need help?
General
