MAX/ MIN/ T/C PROBE [MSPRO]
With this function you can select if the
maximum, minimum or t/c probe value [MSPro]
will be shown permanently in the upper part of
the display. After a measurement (during the
HOLD mode) you can also recall the
respectively non shown values by pressing the
U
P button.
The t/c probe value will be displayed only if a
probe is connected. During the HOLD mode this
value will also be frozen.
A
LARM FUNCTIONS
To activate/ deactivate please press the U
P or
D
OWN button if the H or L is shown in the
display. The alarm function is activated as soon
as the display shows the sign
.
After pressing M
ODE again the alarm values can
be adjusted using the U
P and DOWN button.
If the temperature exceeds the selected High
value an acoustic signal will appear and the
display color will change to RED.
If the temperature falls below the selected Low
value an acoustic signal will appear and the
display color will change to BLUE.
°C/
°F SETTING
Selection of the temperature unit.
O
FFSET
With this function you can set a linear offset
(+/-) to the temperature reading. It allows a field
calibration of several units showing exactly the
same values.
Reset Function
The unit can be reset to the factory default
values by pressing the M
ODE and UP button
simultaneously (during HOLD mode). The Data
logger [MSPro] will not be deleted by this
procedure.
optris MS – DE2011-04-A
30
To Next Page
Loading...
Need help?
General
