The RS485 interface is defined for a length of 500 m.
The process interface has an integrated fail-safe mode. This allows to control conditions like interruption of
cables, shut-down of the software etc. and to give out these conditions as an alarm. The time constant of the
fail-safe is 1.5 seconds.
Controlled conditions on camera and software
Standard Process interface
ACXIIOCB1
Industrial Process interface
ACXIPIFCBxx
Interruption USB cable to camera
Interruption data cable camera - PIF
Interruption power supply PIF
Shut-down of PIX Connect software
Crash of PIX Connect software
0 mA at analog output (AO)
open contact (fail-safe relay)/ green LED off
To Next Page
Loading...