2
Setup and Configuration
This section contains instructions for setting up and configuring the Oracle MICROS
Tablet 720 and the Oracle MICROS Tablet 721/721P.
• Performing an Initial Setup
• Inserting and Removing the Battery
• Charging the Tablet and Battery
• Powering the Tablet On and Off
• Barcode Scanner Configuration
• Using the Barcode Scanner
• Configuring the Barcode Scanner for Use With Oracle Retail Xstore Applications
Performing an Initial Setup
1. Place the tablet face down on a smooth, flat surface.
2. Insert the battery into the battery compartment and gently press down until it clicks
into place.
3. Connect the tablet to its power supply and fully charge.
4. Power on the tablet by pushing and quickly releasing the Power button. The
display powers on in a few seconds.
5. Complete the Microsoft Windows setup by following the prompts. Consult your
network administrator to properly complete the tablet’s network and system
configurations.
6. Ensure the tablet is connected to a secure wireless network.
7. Install the Client Application Loader (CAL) by double-tapping the CALClient
Install icon and following the prompts. Upon successful completion, the tablet is
connected to your application’s CAL server.
Inserting and Removing the Battery
1. To insert the battery, slide the battery into the battery compartment with the
terminal slots aligned with the battery terminals, and then gently push into place.
2. To remove the battery, use the Battery Latch on the back of the tablet to unlock
and release the battery.
2-1
To Next Page
Loading...
Need help?
General
