FDR 70
- If overheated, the safety system turns the device off. In order to restart it, unplug the unit and wait
until it cools. Once cooled, re-plug it in and press the "RESTART" button on the back of the heating
unit. To do so you will need a thin and long tool.
• Never start cleaning until the oil has cooled down.
• Always unplug the fryer before cleaning.
• Pour the oil out of the bowl using the pouring lip on the rim of the bowl.
Fryer body/fixed bowl
• Fryer outer body – wipe with a damp cloth and dry thoroughly. Never put it in water.
• Inner bowl – after each use, fill with hot soapy water and soak for 20 minutes. Then use a
non-abrasive cleaner.
Basket
• After each use, remove and soak in hot soapy water for 20 minutes. Then use a stiff brush.
• The lid and basket can alternatively be washed in your dishwasher.
SERVICE AND CUSTOMER CARE
If you experience any problems with the operation of the fryer, before calling for assistance refer to
the troubleshooting guide.
TROUBLESHOOTING GUIDE
Fryer does not
work
Fryer not plugged in Check fryer is plugged in
Fuse blown Check the fuse/circuit breaker
for your installation and replace
the fuse if necessary. If this does
not solve the problem refer to the “service”
Section.
Overheating Wait for the fryer to cool and press the "RESTART"
button on the back of the head.
Oil overflowing Maximum oil level exceeded Check oil level
Wet food placed in oil Drain and dry food thoroughly
The oil is old and has
deteriorated
Replace with fresh oil
Incorrect oil used/different oils
mixed together
Use a good quality oil suitable for deep frying
Unpleasant
Odour/Oil
smokes
The oil is old and has
deteriorated
Replace with fresh oil
The oil is not suitable for deep
frying
Use a good quality oil suitable for deep frying
Poor frying
performance
Incorrect temperature used Select the correct temperature
Basket overloaded Reduced the quantity fried
Fresh chips too wet Drain and dry the chips thoroughly
To Next Page
Loading...
