Operation Manual
"Open Frame Welding Head OSW Series"
11
On the power supply there is a C 016 socket (plastic, Amphenol) marked in green. The short green control unit
connection cable is connected to this.
The yellow motor control cable is connected directly to the control unit. The socket (yellow) is labelled with an
arrow for the turning direction and also with two rollers and an arrow for the wire feed direction.
(With open tools such as open frame weld heads, turntable welding and tube to tubesheet weld heads, wire is
often used. When using closed weld heads (enclosed chamber weld head), no wire is used.)
control unit cable
Five-pole connector for the
Manual TIG hose package
Connector for motor control cable with
and without wire feed
Connector for wired re-
mote control
To Next Page
Loading...
