Orca 40 CL - Page 167

167
UTILISATION
167
INSTALLATION
UISTITE SA PROSÍM, ČI JE HORNÝ KRYT VYSÁVAČA PEVNE PRIPEVNENÝ
K PODVOZKU.
PRI NABÍJANÍ JE PRÍSNE ZAKÁZANÉ OBRACAŤ VYSÁVAČ DNOM NAHOR,
ABY NEDOŠLO K POŠKODENIU VÝKYVNEJ DOSKY.
PRI UPEVŇOVANÍ HORNÉHO KRYTU
K PODVOZKU DBAJTE NA SPRÁVNY SMER
INŠTALÁCIE, AKO JE ZNÁZORNENÉ NA
NIŽŠIE UVEDENOM OBRÁZKU: POLOHA
ŠÍPKY PRI SPONE HORNÉHO KRYTU
MUSÍ BYŤ V JEDNEJ LÍNII S OTVOROM
V BLÍZKOSTI SPONY PODVOZKU.
POKYNY NA POUŽITIE
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.