Orca 40 CL - Page 87

87
UTILISATION
87
INSTALLATION
CERTIFIQUE-SE DE QUE A TAMPA SUPERIOR DO ASPIRADOR ESTÁ BEM MONTADA
NO RESPETIVO CHASSIS.
AO EFETUAR O CARREGAMENTO, É ESTRITAMENTE PROIBIDO VIRAR A PARTE
INFERIOR PARA CIMA PARA EVITAR QUE A PLACA OSCILANTE SEJA ESMAGADA.
AO FIXAR A TAMPA SUPERIOR E O
CHASSIS, CONCENTRE-SE NA DIREÇÃO DE
INSTALAÇÃO, COMO DEMONSTRADO PELA
FIGURA PRESENTE ABAIXO: A POSIÇÃO DA
SETA PERTO DA FIVELA DA TAMPA SUPERIOR
DEVE FICAR ALINHADA COM A POSIÇÃO DO
BURACO PERTO DA FIVELA DO CHASSIS.
INSTRUÇÕES DE FUNCIONAMENTO
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.