EasyManua.ls Logo

OREC FL 500 - Page 16

OREC FL 500
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OREC FL500A - © SAT 03/03
16
MAINTENANCE CHART
Ask your dealer to realize this operation needing special tools and knowledge.
⊕ Inspection to realize by the owners before starting the engine
⊗ Inspection to realize by the owners after starting the engine
Part to inspect
Inspection
Every
use
first
20
hours
Every
100
hours
Every 300
hours or
Every year
Blade belt
Check belt tension
Check wear
Fuel
refuelling
⊕
Fuel cock
⊕
Flammables
materials
Clean the machine from flammables
materals
⊕
Drive clutch lever
check machine do not move when
lever is on “N”
⊗
Check travel lever goes on “N” when
applying brake
⊗
Chasis
Check for rust, and cracks
Safety stickers Check they are in place and in good
condition
⊕
Safety switches
Check for efficiency
⊗
Guards & shields
Check they are bolted in their place
and in good condition
⊕
Tank and fuel
hoses
Check for leaks and good condition
Replace if needed
⊕
Throttle lever
Check for efficiency
⊗
Blades
Check they are bolted in their place
and in good condition
⊕
Blade clutch
control lever
Check the adjustment of the wire
⊕
Blade brake
Check the adjustment
⊕
Blade belt
Check they tensionned and in good
condition
Engine
Refer to engine manual
Rear Wheel
Clean inside of wheel
Check if gears are properly greased.
⊕