OREC RM83G - Page 17

OREC RM83G - © SAT 03/2015
17
DANGER
Check that the fuel tank cap is closed properly, wipe leaky fuel before to start the machine.
Check there is no fire, electric sparks, cigarettes near the machine when refuelling.
When the machine is used on slopes, work with the fuel tank half full to avoid fuel leaking.
Remove flammable materials :
Remove flammable materials espacially near hot parts such as mufflers or engines.
It might cause fire.
Tires (Figure18)
 Check the tires are not cutted, cracked or worn.
 Check the pressure of the tires : 1,2 bar front and 1,4 bar
rear.
Safety stickers
Check the safety stickers are sticked at their location. Replace
them if they are worn and damage.
Latelal guards and shields
Check that the lateral guards and the shields are bolted.
Electrolyte battery level (Figure 19)
Check that the telectrolyte level is between the upper and
the lower level. Add distilled water as requiered.
DANGER
Be carefull when maintening the battery. Avoid flames, and
sparks. Always wear gloves and glasses. Wash with water
if you are hit by electrolyte.
B
lade and blade holder condition
Check that the rotary blades are in a good condition, change
worn or damaged parts.
How to replace blades :
1. Remove the Blade by loosening the Hard Lock Nut.
Remove the Upper nut, and then remove the Lower nut.
2. After changing a new Blade (or to the reversed blade)
It also should be changed to a new Blade Bolt, Hard Lock Nut
and Nut Guard as shown by Figure 20.
CAUTION
The cutting blade can cut user’s hand. You can be cut and
injuried by cutting blade. Always wear gloves when holding
blades.
F
Too
high
OK
Too
low
Figure 18
Figure 19
Upper
Level
Lower
Level
Battery
TIRES PRESSURE
Upper
Nut
Lower
Nut
Hard Lock Nut
Nut guard
Blade
Stay
Blade
Blade set bolt
Knife collar
Figure 20