Oreck Grab It & Steam It - Steam Mop Operation

7
ENGLISH
Operation
continued
Align and attach Velcro
®
on the microber steam mop pad to the Velcro
®
on the microber
steam mop pad holder.
To attach the Grab-It & Steam-It’s microber steam mop pad holder, place foot on release pedal
and gently push down, lower the power head onto the microber steam mop pad holder and
LIGHTLY press down to snap into place.
NOTE: Never operate the steam mop without the microber steam mop pad in place.
Grasp the water tank release lever and pull forward to remove the water tank.
Remove cap from the water tank bottom and ll with water. Replace the cap and reinstall the
water tank.
NOTE: Do not attempt to use steam mop without water in tank.
1
2
3
1 2
3 4
4
Release Pedal
Steam Mop Operation: