15
6. TROUBLESHOOTING
Service problems that appear to be major can often be solved easily. This guide can help you
troubleshoot.
All other servicing should be done by an Oreck authorized service center.
PROBLEM CHECK SOLUTION
UNIT DOES NOT
TURN ON
• NO VOLTAGE IN
WALL PLUG
• BLOWN FUSE OR
TRIPPED BREAKER
• SELECTOR SWITCH
• TOP COVER
• ALCI PLUG
• CHECK FUSE OR BREAKER IN HOME
• REPLACE FUSE OR RESET BREAKER IN HOME
• SET SELECTOR SWITCH FOR DESIRED BLOWER SPEED.
• MAKE SURE THE TOP COVER IS SECURELY CLOSED
• PRESS THE RED RESET BUTTON EACH TIME YOU
PLUG IN THE ALCI SAFETY DEVICE.
TRUMAN CELL
LIGHT HAS TURNED
SOLID RED.
TRUMAN CELL A SOLID RED LIGHT IS A 30 DAY CLEANING REMINDER.
WASH COLLECTOR CELL. MAKE SURE IT IS THOROUGHLY
CLEAN AND DRY BEFORE REINSTALLING.
TRUMAN CELL
LIGHT IS
BLINKING RED
TRUMAN CELL • A FAST BLINKING LIGHT INDICATES THE POWER
SUPPLY HAS SHUT DOWN DUE TO ARCING OR
SHORT CIRCUIT. THE CELL SHOULD BE INSPECTED
AND CLEANED, REPAIRED, OR REPLACED.
• A SLOW BLINKING LIGHT INDICATES THE UNIT
IS IN DRY MODE.
UNIT DOES
NOT REMOVE
POLLUTANTS.
TRUMAN CELL • CLEAN THE TRUMAN CELL AND MAKE SURE IT
IS COMPLETELY DRY BEFORE REINSTALLING.
• TRUMAN CELL MAY BE DAMAGED. CONTACT
ORECK FOR SERVICE.
UNIT SPARKS,
CRACKLES
AND POPS.
TRUMAN CELL • SPARKING OR POPPING NOISE (ARCING) CAN
OCCUR WHEN A LARGE PARTICLE IS CAPTURED
IN THE TRUMAN CELL. IF THE UNIT IS ARCING
EXCESSIVELY, THE CELL MAY BE DIRTY. TRY
CLEANING THE TRUMAN CELL.
• IF EXCESSIVE ARCING CONTINUES AFTER
PROPER CLEANING, THE TRUMAN CELL MAY
BE DAMAGED OR WET. IF DAMAGED, CONTACT
ORECK FOR SERVICE.
TO REDUCE THE RISK OF ELECTRIC SHOCK— UNPLUG BEFORE CLEANING OR SERVICING. IF
APPLIANCE IS NOT WORKING AS IT SHOULD, HAS BEEN DROPPED, DAMAGED, LEFT OUTDOORS, OR
DROPPED INTO WATER, TAKE IT TO A SERVICE CENTER PRIOR TO CONTINUING USE.
WARNING!
To Next Page
Loading...
