7
Use
Connect Hose
• With hose toward rear of the vacuum, push hose
connector into opening in the bag lid.
Note: The exible hose contains electrical wires for
connection to the power nozzle and should not be used
if damaged. The wires should not be visible through
the outer skin.
Connect Hose Handle to Wand
• Attach the hose to the telescopic wand by pushing the
handle (E) down into wand until the Handle Release
button (F) locks the handle into place.
Connect Wand to Nozzle
• Attach the wand to power nozzle by tting the button
on the wand (G) into nozzle connector opening (H).
Be sure nozzle is locked in place.
• To release, press down on the wand release pedal (I)
and remove the wand.
To Next Page
Loading...
